Turbelle® nanostream® 6095
WIDE FLOW
For aquariums from 100 to 1,000 liters
(25 to 265 USgal.).
Flow rate: 2,000 to about 9,500 l/h
(550 to about 2,500 USgal./h)
with Turbelle® controller
Energy consumption: 5 - 21 W
Power supply unit: 100-240V / 50-60Hz
Cable length: 3 m (118”)
Dimensions: ø70 mm (2.7”)
Output: ø50/10 mm (2/.4”)
Magnet Holder with Silence clamp up to a glass thickness of 15 mm (2/3”).
1: Deutsch, English, Francais (x6045.8888) 2: Italiano, Espanol, РУССКИЙ (x6045.8882) 3: 中国 (x6045.8883)
Specifications
nanostream® design
Turbelle® nanostream® electronic 6055 and 6095 are speed-controlled pumps with a Turbelle® controller operating on safety extra-low voltage, to be employed ideally in every aquarium from 40 to >1,000 liters (10 to >265 USgal.) for simulation of lapping waves or tidal currents. They contain a microprocessor-controlled motor and a Turbelle® controller. The electronic motor adapts its speed automatically to the pump load and always seeks the best efficiency at the lowest possible consumption of energy. The pumps will be stopped immediately in case of blockage. After the blockage has been removed, the pumps will start up automatically after a delay of 20 seconds. The pump driver has been provided with a fish care function, which causes a revolution of the propeller every twenty seconds when the pump is at a standstill. It can be controlled by the Multicontroller / SmartController 7000.
Electronically controllable synchronous motor pumps - Turbelle® Controller included
The Turbelle® controller is a device that is used to set the variable pump performance. It can provide a wave simulation, oscillation flow, an automatic search for the resonance frequency when the oscillation flow is used, and it is also equipped with a food timer. It can be directly connected to a Multicontroller / SmartController 7000. The pump is therefore able to operate together with other pumps, for example, in the high/low tide mode. If the Moonlight 7097.050 (not included in the scope of delivery) is attached to the Turbelle® controller, the night-mode operation will be activated automatically. If this controller is connected to a second controller with the 7092.300 cable, a further pump can be connected and controlled, for example, to provide a wave pounding simulation or an oscillating current. A third controller can be added using the Y adapter cable 7090.300.
Flow profile
An intelligent and innovative micro-processor...
controlled PM motor operating on safety extra-low voltage of 12 V to 24 V is the core of the Turbelle® masterstream.
Controllable speed, wave simulation, tidal...
currents
Low motor heat
3D adjustment
Includes Magnet Holder
Includes Silence clamp
